Makerbot Replicator 2x Journal Entry 3
Yesterday I received the new thermocouple cable from Makerbot. I have not installed it yet.
I’ve been too busy with work and other things to really mess around with my 3D printer more.
Similar Posts
Working on Test Connector
Yesterday evening I started working again on the design of a female connection piece. The model I am working on (which I want…
PLA Printing Saga Continues
I did a print on my Makerbot Replicator 2 in True Yellow PLA filament. It was truly a bear to remove it from…
3D Printing Update – Some of what’s Happened and What I’ve Learned
Oh heck! I have been neglecting my blog for long enough! Due to the dearth of posts on 3D Printing you might suspect…
Time-Out ,3D Printing Stuff, Web Stuff and More
I’ve been off of work since just before Thanksgiving and for the month December. After a really hard year of work I finally…
Printing in PLA is Frustrating So Far
I have a Makerbot Replicator 2X 3D Printer. It can print in both ABS and PLA plastic filaments. So far, the only plastic…
Getting PLA Prints to Stick Without a Raft
Printing in PLA on my Makerbot Replicator 2 with a raft is pretty reliable. There are a few problems with this though: I…