PLA Printing Saga Continues
I did a print on my Makerbot Replicator 2 in True Yellow PLA filament. It was truly a bear to remove it from the blue painter’s tape covered build platform. The print actually split/cracked some as I tried to remove it! Not good! π
I notice that to some extent, as the plastic shrinks, it starts lifting the painter’s tape up off the platform little by little. I am replacing the tape quite often.
I noticed when I went to the Microsoft Store and saw their demo printer printing thing that their printer’s build plate was covered with something different, and that they seemed to not be having the problems of their prints either not sticking or sticking way too much. Hmmm. So I went back to their store to ask some questions. It seems that they have been using a stick-on Skinz layer that sticks to the build plate and then trim it with a razor. The guy I was talking with said that it seems to last about a month for them. And… he gave me a sheet of the stuff to try out! π
I have applied it my build plate! The logos printed on it are crooked and upside down… But do I care? No, I am not after fashion… I am after better success with my 3D Prints! I will let you know how this goes.